• Maximum Airflow at 100 PSI: 3/4: 220 SCFM
• Maximum Working Pressure: 300 PSI
• Pressure Range: 5-160 PSI
• Working Temperature: 0 to 65 °C
• Pressure Gauge Port Size: 1/4 (F) NPT
• Panel Mount Opening: 6.7 cm
Material(s):
• Body: Zinc
• Cap: Zinc / Brass
• Piston: Acetal
• Seals: Nitrile
• Springs: Steel
• Valve Assembly: Brass / Nitrile / Acetal
• Speeds up adjustments
• Saves time and money when pressure needs to be reset often
• Maintains a stable pressure throughout a flow range with very little pressure drop
• Maximum pressure can be set to avoid overpressure and tampering
• 160 PSI calibrated dial face for quick reading and setting
• Constant bleed relieving design ensures quick response to pressure changes
• High flow, low pressure drop design
• Panel mountable through a 6.7 cm hole using four mounting holes
• Dual 1/4 NPT gauge ports can also be used as additional outlet ports
HOW IT WORKS
Standard regulators are set by turning the knob clockwise from a lower pressure, which works fine when raising the pressure; however, when lowering the pressure the knob must be turned counter clockwise until pressure drops below the desired pressure and then turned clockwise again up to the desired pressure. This takes time and leaves room for error.
Using a QUICK-SET dial regulator eliminates this long process by allowing to simply set the knob to the desired pressure.
WHERE TO INSTALL A REGULATOR
Install the regulator on each pipe where applications and air tools requires different working pressure
Always install the regulator downstream of a filter and upstream of a lubricator
Can be installed vertically or horizontally
Always install regulator with the arrows pointing to the tool or application
• Ideal for control panels, production line or laboratory applications where pressure is often reset
• Maximum Airflow at 100 PSI: 3/4: 220 SCFM
• Maximum Working Pressure: 300 PSI
• Pressure Range: 5-160 PSI
• Working Temperature: 0 to 65 °C
• Pressure Gauge Port Size: 1/4 (F) NPT
• Panel Mount Opening: 6.7 cm
Material(s):
• Body: Zinc
• Cap: Zinc / Brass
• Piston: Acetal
• Seals: Nitrile
• Springs: Steel
• Valve Assembly: Brass / Nitrile / Acetal
• Speeds up adjustments
• Saves time and money when pressure needs to be reset often
• Maintains a stable pressure throughout a flow range with very little pressure drop
• Maximum pressure can be set to avoid overpressure and tampering
• 160 PSI calibrated dial face for quick reading and setting
• Constant bleed relieving design ensures quick response to pressure changes
• High flow, low pressure drop design
• Panel mountable through a 6.7 cm hole using four mounting holes
• Dual 1/4 NPT gauge ports can also be used as additional outlet ports
HOW IT WORKS
Standard regulators are set by turning the knob clockwise from a lower pressure, which works fine when raising the pressure; however, when lowering the pressure the knob must be turned counter clockwise until pressure drops below the desired pressure and then turned clockwise again up to the desired pressure. This takes time and leaves room for error.
Using a QUICK-SET dial regulator eliminates this long process by allowing to simply set the knob to the desired pressure.
WHERE TO INSTALL A REGULATOR
Install the regulator on each pipe where applications and air tools requires different working pressure
Always install the regulator downstream of a filter and upstream of a lubricator
Can be installed vertically or horizontally
Always install regulator with the arrows pointing to the tool or application
• Ideal for control panels, production line or laboratory applications where pressure is often reset